Center Console Ashtray Block Off
1984-1989 Toyota 4runner 1st Gen
Description
This is a block off plate for the rear ash tray of a 1st gen 4runner. I didn't have the factory ash tray to cover up the hole, so i decided to make a cover for it. I did make the final print out of abs, but I wouldn't use it again to print this part out, as I couldn't stop the bottom edge of the print from warping. If I was to print this again, I would try petg instead. The cad file has hole designs in it for carlington rocker switches and a 12 volt outlets, but i didn't publish them because I haven't been able to test to see if switches would actually fit in the center console. Feel free to modify the cad file or let me know if you would want them in stl's for something.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a block off plate for the rear ash tray of a 1st gen 4runner. I didn't have the factory ash tray to cover up the hole, so i decided to make a cover for it. I did make the final print out of abs, but I wouldn't use it again to print this part out, as I couldn't stop the bottom edge of the print from warping. If I was to print this again, I would try petg instead. The cad file has hole designs in it for carlington rocker switches and a 12 volt outlets, but i didn't publish them because I haven't been able to test to see if switches would actually fit in the center console. Feel free to modify the cad file or let me know if you would want them in stl's for something.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed