Sunvisor Mount
1984-1989 Toyota 4runner 1st Gen
Description
This is a sun visor mount for 1984-1989 Toyota Pickups and 4runners. The mount hangs the sunvisor a little lower than stock, but that's due to that way I attached it the the sunvisor stem, with a 1/4x20 nut. The mount is the same for both sides of the truck. The Solidworks file is attached incase modifications are needed. The mount stem would need to be longer if you wanted to reuse OEM clip. To try and get the most strength that i could, i printed the mounts at about a 35 degree angle with tree supports. Printed on a Bambu Lab P2S out of abs and with 100% infill. (Driver side visor is my 3d print)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a sun visor mount for 1984-1989 Toyota Pickups and 4runners. The mount hangs the sunvisor a little lower than stock, but that's due to that way I attached it the the sunvisor stem, with a 1/4x20 nut. The mount is the same for both sides of the truck. The Solidworks file is attached incase modifications are needed. The mount stem would need to be longer if you wanted to reuse OEM clip. To try and get the most strength that i could, i printed the mounts at about a 35 degree angle with tree supports. Printed on a Bambu Lab P2S out of abs and with 100% infill. (Driver side visor is my 3d print)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed