Battery Holddown
1985 Toyota Mr2 AW11
Description
My aw didn't come with the battery hold down and nobody online sells ones that fit the special battery holder thing on this old car, so I modeled it. For screws I used 1x 14" J-bolt and 1x 1/4-3/4 bolt from ace the helpful place (tacoma screw was closed). Depending on how large of a bolt you use for the upper flange, you might need some washers to act as spacers. Hope this helps someone. Seems to do a half-decent job of holding my battery in place.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
My aw didn't come with the battery hold down and nobody online sells ones that fit the special battery holder thing on this old car, so I modeled it. For screws I used 1x 14" J-bolt and 1x 1/4-3/4 bolt from ace the helpful place (tacoma screw was closed). Depending on how large of a bolt you use for the upper flange, you might need some washers to act as spacers. Hope this helps someone. Seems to do a half-decent job of holding my battery in place.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed