Dash Bezel For Atoto S8 Standard 7" Radio/nav Unit
1988 Suzuki Samurai
Description
This project is a work in progress, feel free to edit as necessary. This is a custom dash bezel to fit a newer double-din sized radio into the Suzuki Samurai, specifically the square vent model. This will fit an ATOTO S8 Standard 7" screen into the top of the middle dash where the clock normally sits. Before this will work you will need to dremel/cut out the top hole in the middle dash flush with the surrounding outside bezel. Pull your existing radio wires up beside the instrument cluster and into the new cut out area. This model will fit snug into opening cut out from the clock area, you may have to get creative on additional mounting of the 3D printed bezel (Screws, brackets, etc.) Note: The method of installation makes it difficult to reach the two middle dash screws behind the screen. I left the out on my install. This model needs to have supports enabled on the overhang to the bed.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This project is a work in progress, feel free to edit as necessary. This is a custom dash bezel to fit a newer double-din sized radio into the Suzuki Samurai, specifically the square vent model. This will fit an ATOTO S8 Standard 7" screen into the top of the middle dash where the clock normally sits. Before this will work you will need to dremel/cut out the top hole in the middle dash flush with the surrounding outside bezel. Pull your existing radio wires up beside the instrument cluster and into the new cut out area. This model will fit snug into opening cut out from the clock area, you may have to get creative on additional mounting of the 3D printed bezel (Screws, brackets, etc.) Note: The method of installation makes it difficult to reach the two middle dash screws behind the screen. I left the out on my install. This model needs to have supports enabled on the overhang to the bed.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed