Vent Gauge Pod
1998-2006 Bmw 3 Series E46
Description
A 52mm gauge pod meant to fit into the driver side air vent. Fits into the factory vent fin mounting holes. NOTE: Some people are having issues figuring out the size to print so I am adding this edit. The width from the front of the pod to the rear is 40mm. To reword this, the smallest axis should be 40mm, the middle would be around 60mm.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.
Part Description
A 52mm gauge pod meant to fit into the driver side air vent. Fits into the factory vent fin mounting holes. NOTE: Some people are having issues figuring out the size to print so I am adding this edit. The width from the front of the pod to the rear is 40mm. To reword this, the smallest axis should be 40mm, the middle would be around 60mm.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.