Console Cupholder Lower Part
1998-2000 Volvo V70
May 10, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
Replacement for the part of the console cup holder that drops down and supports the bottom of a drink. Should work for Volvo V70 and S70 models from 1998 to 2000. You probably don't want to print this in PLA; print in ABS or some other material that can handle being in a hot car.
Print Instructions
As mentioned above, printing this in PLA is probably a bad idea. This is not a copy of the original Volvo part but it should be functionally equivalent. I tried to minimize the need for support but the axle pegs will most likely need them. (I needed supports for the pegs while printing on a Makerbot Dual.) You will probably need to press hard to get the pegs into the console; be careful not to bend the pegs too much.
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
Replacement for the part of the console cup holder that drops down and supports the bottom of a drink. Should work for Volvo V70 and S70 models from 1998 to 2000. You probably don't want to print this in PLA; print in ABS or some other material that can handle being in a hot car.
Print Instructions
As mentioned above, printing this in PLA is probably a bad idea. This is not a copy of the original Volvo part but it should be functionally equivalent. I tried to minimize the need for support but the axle pegs will most likely need them. (I needed supports for the pegs while printing on a Makerbot Dual.) You will probably need to press hard to get the pegs into the console; be careful not to bend the pegs too much.