Slide Out Cup Holder Arm
2002 Subaru Forester
Description
Made to replace the flimsy and broken arm on the slide out cup holder for my 2002 Subaru Forester. Recommend the newer v14 version which has a 1/16" hole to insert a small screw, instead of the printed pin. Should be much stronger that way. I also shortened the other pin to make it's length match the arms surface to it prints better without a raft/supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.
Part Description
Made to replace the flimsy and broken arm on the slide out cup holder for my 2002 Subaru Forester. Recommend the newer v14 version which has a 1/16" hole to insert a small screw, instead of the printed pin. Should be much stronger that way. I also shortened the other pin to make it's length match the arms surface to it prints better without a raft/supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.