Clutch Alignment Tool
2003-2006 Bmw 3 Series E46
Description
22 spline clutch tool used for post 03 3 series. This was specifically for the m54 b25. The shaft is 15mm (into pilot bearing) and the spline circle diameter is 29mm. This size might have also been used for 6 speed but I don't know. The tool itself does not have a handle but you could easily extend it's length in blender. Main reason I didn't make one is because the printing would take much longer. It is possible to "weld" the PLA with a hot knife onto another piece if you want to model one, or I can. Comment below if that's something you are interested in. You can also use a bolt to push into the supports. The PLA plastic is thin enough to be molded by the threads. I used Mattercontrol for this.
Print Instructions
No special print instructions provided.
Fit Reports
How this part printed and fit, from the community.
Part Description
22 spline clutch tool used for post 03 3 series. This was specifically for the m54 b25. The shaft is 15mm (into pilot bearing) and the spline circle diameter is 29mm. This size might have also been used for 6 speed but I don't know. The tool itself does not have a handle but you could easily extend it's length in blender. Main reason I didn't make one is because the printing would take much longer. It is possible to "weld" the PLA with a hot knife onto another piece if you want to model one, or I can. Comment below if that's something you are interested in. You can also use a bolt to push into the supports. The PLA plastic is thin enough to be molded by the threads. I used Mattercontrol for this.
Print Instructions
No special print instructions provided.
Fit Reports
How this part printed and fit, from the community.