Door Switch Clip
2003-2008 Ford Crown Victoria
Description
Does your 03-08 Ford Crown Victoria suffer from flappy drivers door switches? Well, suffer no longer with this clip! Update: my version tends to fail along the layer lines. I've been using the thickened version in the remixes for about 6 months with no issues. Update: there is now an untested version for the passenger side. I printed this with PLA+ as its the highest temp materiel I have on hand but the higher temp material you print it with the more likely it is to last! To install simply remove the trim panel and cut away the remnants of the old clip. Then unplug the door lock switch and slide the printed part over the switch. It should slide to be flush with the switch and be snug. Then plug the door lock switch back in and install the panel the same way you would with the factory clip. Feel free to leave comments with questions or criticism. You can also send me a direct message on Instagram @dog_gone_studios. I'd love to see pictures of your prints!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Does your 03-08 Ford Crown Victoria suffer from flappy drivers door switches? Well, suffer no longer with this clip! Update: my version tends to fail along the layer lines. I've been using the thickened version in the remixes for about 6 months with no issues. Update: there is now an untested version for the passenger side. I printed this with PLA+ as its the highest temp materiel I have on hand but the higher temp material you print it with the more likely it is to last! To install simply remove the trim panel and cut away the remnants of the old clip. Then unplug the door lock switch and slide the printed part over the switch. It should slide to be flush with the switch and be snug. Then plug the door lock switch back in and install the panel the same way you would with the factory clip. Feel free to leave comments with questions or criticism. You can also send me a direct message on Instagram @dog_gone_studios. I'd love to see pictures of your prints!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed