Center Console Latch
2003 Honda Pilot
Description
The latch broke on the center console for my 2003 Honda Pilot, so I measured it and printed a new part. The same part almost certainly was used for other Honda models and years, but I can't be certain. I printed it on its side (with supports) in nylon, but I'm sure PETG would make an acceptable material. Do NOT use PLA; it won't last in the summer sun and it's also too brittle.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
The latch broke on the center console for my 2003 Honda Pilot, so I measured it and printed a new part. The same part almost certainly was used for other Honda models and years, but I can't be certain. I printed it on its side (with supports) in nylon, but I'm sure PETG would make an acceptable material. Do NOT use PLA; it won't last in the summer sun and it's also too brittle.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed