Windshield Washer Hose Splitter
2004 Ford F-150
Description
I designed and printed this as a replacement to the windshield washer hose splitter that broke on my 2004 Ford F-150. In this application, the splitter is located under the windshield wiper cowl, so PLA should hold up. If this is used in an application where the splitter is located in the engine bay, something like PETG may need to be used. I printed this on my Anet A8 in the upright position, and it did not need any rafts, brims, or support of any kind.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I designed and printed this as a replacement to the windshield washer hose splitter that broke on my 2004 Ford F-150. In this application, the splitter is located under the windshield wiper cowl, so PLA should hold up. If this is used in an application where the splitter is located in the engine bay, something like PETG may need to be used. I printed this on my Anet A8 in the upright position, and it did not need any rafts, brims, or support of any kind.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed