Cubby Clip Tab Fix
2005 Nissan 350z
Description
This is for the two cubbies behind the seats in the 350z. Mine came with both of the hooks broken off and missing, so I designed new ones. Prep - use a dremel or razor to clean out and make a level spot where the broken off hook was. Printing - I recommend using something like ABS or PETG. The model is set for PLA prototypes. When I printed using inland black PETG, it didn't work. To fix this, I multiplied the z height by 1.2 in the slicer and then it worked. I also printed with 100% infill. Post printing - simply, clean up the part as needed. Put a drop or two of super glue and hold it there, making sure it is aligned before it dries fully.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is for the two cubbies behind the seats in the 350z. Mine came with both of the hooks broken off and missing, so I designed new ones. Prep - use a dremel or razor to clean out and make a level spot where the broken off hook was. Printing - I recommend using something like ABS or PETG. The model is set for PLA prototypes. When I printed using inland black PETG, it didn't work. To fix this, I multiplied the z height by 1.2 in the slicer and then it worked. I also printed with 100% infill. Post printing - simply, clean up the part as needed. Put a drop or two of super glue and hold it there, making sure it is aligned before it dries fully.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed