Ashtray
2006 Kia Cerato
Description
Update pending: PLA melted in Australian heat. I will also resize the runners eventually to fit better. A very rough remix (copy pasta) on another car ashtray. Someone stole my original :( Shouldn't be too hard to resize for other models This should fit a Kia Cerato 2006 Should be right to print on just about any setting, but I used: Nozzle: 0.4mm Walls: 0.4mm Height: 1.2mm Support: Touching Plate Infill: 100 Takes a little over 12hrs to print on my Anet A8 at 30mm/sec
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Update pending: PLA melted in Australian heat. I will also resize the runners eventually to fit better. A very rough remix (copy pasta) on another car ashtray. Someone stole my original :( Shouldn't be too hard to resize for other models This should fit a Kia Cerato 2006 Should be right to print on just about any setting, but I used: Nozzle: 0.4mm Walls: 0.4mm Height: 1.2mm Support: Touching Plate Infill: 100 Takes a little over 12hrs to print on my Anet A8 at 30mm/sec
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed