Boot Lid Position Mount
2007 Subaru Legacy (GT)
Description
When putting a spoiler on the car you can see that there is some play on the boot. Removing the inner boot mounts gets rid of the play on the boot but it doesn't close properly at times. Boot_Lid_position_mount_center (Printed in PETG goes into the other part) There are 3 different options of the below part depending on the play you have on your boot. (Printed in TPU) Boot_Lid_position_mount_Rubber_-5mm_Shorter (5mm shorter than the original length) Boot_Lid_position_mount_Rubber_+5mm_Longer (5mm longer than the original length) Boot_Lid_position_mount_Rubber_Exact_Length (original length if one may have been lost)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
When putting a spoiler on the car you can see that there is some play on the boot. Removing the inner boot mounts gets rid of the play on the boot but it doesn't close properly at times. Boot_Lid_position_mount_center (Printed in PETG goes into the other part) There are 3 different options of the below part depending on the play you have on your boot. (Printed in TPU) Boot_Lid_position_mount_Rubber_-5mm_Shorter (5mm shorter than the original length) Boot_Lid_position_mount_Rubber_+5mm_Longer (5mm longer than the original length) Boot_Lid_position_mount_Rubber_Exact_Length (original length if one may have been lost)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed