Cup Holder Extender
2008-2012 Ford Escape
Description
Title is self-explanatory This sits inside the existing cupholder and extends it so you can put mugs, yeti water bottles, mason jars, shaker cups etc into it. Printed with PETG as PLA will deform if left in a hot car. Supports from build surface only. Can just cut the bottom piece of by taking 0.811" off of the Z-axis, it will fit just fine without it
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.
Part Description
Title is self-explanatory This sits inside the existing cupholder and extends it so you can put mugs, yeti water bottles, mason jars, shaker cups etc into it. Printed with PETG as PLA will deform if left in a hot car. Supports from build surface only. Can just cut the bottom piece of by taking 0.811" off of the Z-axis, it will fit just fine without it
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.