Windshield Washer Reservoir Cap
2008 Mercedes Sprinter
Description
The factory cap for the windshield washer fluid reservoir is flimsy. This cap should outlast the vehicle if you printer produces a dense part without voids. I made it a little loose fitting because it has a hole for a lanyard to keep from losing it. Better than breaking the cap or getting it stuck on. Could scale the whole part just a bit to make it fit tighter without changing any critical dimensions. i made the cap fit tighter, a little thicker and added a few more fillets to increase strength. it is quite a lot better now.
Print Instructions
printed it on my Solidoodle III using a .2 mm layer. don't recommend a Solidoodle, they are terrible without major modifications as mine has received.
Part Description
The factory cap for the windshield washer fluid reservoir is flimsy. This cap should outlast the vehicle if you printer produces a dense part without voids. I made it a little loose fitting because it has a hole for a lanyard to keep from losing it. Better than breaking the cap or getting it stuck on. Could scale the whole part just a bit to make it fit tighter without changing any critical dimensions. i made the cap fit tighter, a little thicker and added a few more fillets to increase strength. it is quite a lot better now.
Print Instructions
printed it on my Solidoodle III using a .2 mm layer. don't recommend a Solidoodle, they are terrible without major modifications as mine has received.