Cobb Accessport Mount
2008-2011 Subaru Impreza
Description
A mount for a v2 accessport for my 2010 STI. Double-sided tape alone does not work well enough, use a small zip tie to anchor the mount to the dash. No modifications to the dash are required, the knurl the zip tie end a bit and cram it into the gap in the dash panels, cut off the end and zip it tight as shown. printed in pteg. may improve the curves to fit the dash better in the future, but this works. Prints without supports, print with the large flat surface down.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
A mount for a v2 accessport for my 2010 STI. Double-sided tape alone does not work well enough, use a small zip tie to anchor the mount to the dash. No modifications to the dash are required, the knurl the zip tie end a bit and cram it into the gap in the dash panels, cut off the end and zip it tight as shown. printed in pteg. may improve the curves to fit the dash better in the future, but this works. Prints without supports, print with the large flat surface down.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed