Start Button Holder
2010 Ford Taurus
Description
This is a replacement for the clip that holds the start button in place on a ford Tarus. This was modeled on a 2010 Sho model. Slightly reinforced. Printed in PLA could be printed in something stronger. I did not use supports for the arch part. The part is not available except with the entire trim piece for an extraordinary amount of money
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.
Part Description
This is a replacement for the clip that holds the start button in place on a ford Tarus. This was modeled on a 2010 Sho model. Slightly reinforced. Printed in PLA could be printed in something stronger. I did not use supports for the arch part. The part is not available except with the entire trim piece for an extraordinary amount of money
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.