Key Holder
2010 Toyota Yaris
Description
This was a fun project to work on so what I did was take a top view photo of the key next to a ruler so I could get the scaling correct. I took that picture and drew an outline of the key in solid works and then with a couple iterations was able to get a fully functional key holder. The reason why I printed this holder was because I kept breaking the original holder and each time to replace would cost 15$, not sure if any Toyota owners are having this problem but I hope this helps. Please keep in mind this holder is for a 2010 Toyota Yaris 4dr Sedan you must transfer the key and transponder chip or the car wont turn on.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This was a fun project to work on so what I did was take a top view photo of the key next to a ruler so I could get the scaling correct. I took that picture and drew an outline of the key in solid works and then with a couple iterations was able to get a fully functional key holder. The reason why I printed this holder was because I kept breaking the original holder and each time to replace would cost 15$, not sure if any Toyota owners are having this problem but I hope this helps. Please keep in mind this holder is for a 2010 Toyota Yaris 4dr Sedan you must transfer the key and transponder chip or the car wont turn on.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed