Yakima Landing Pad Skirt Adapter
2011-2021 Dodge Durango
Description
These are custom "skirts" made to adapt the "bases" from a Yakima Landing Pad 16 or 18 kit to be used with the factory Stow 'N Place roof rails on a third generation Dodge Durango. Very likely, something similar to these could also work for a current gen Pacifica or Caravan. In addition to these prints, you would still need to fab up the metal dogs that the M8 bolts thread into to hold these in place. Take a look at the business end of your factory crossbars to understand how those work. Prints are lettered, A, B/C, & D. The only difference between them is a slight notch out of the corners to clear some raised lettering on the factory roof rails to ensure no modification needs to be done to the factory plastic. Did a full writeup on a Dodge Durango forum if you'd like some more details: https://www.dodgedurango.net/threads/aftermarket-crossbars-on-factory-stow-n-place-roof-rails-heres-an-idea.79581
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
These are custom "skirts" made to adapt the "bases" from a Yakima Landing Pad 16 or 18 kit to be used with the factory Stow 'N Place roof rails on a third generation Dodge Durango. Very likely, something similar to these could also work for a current gen Pacifica or Caravan. In addition to these prints, you would still need to fab up the metal dogs that the M8 bolts thread into to hold these in place. Take a look at the business end of your factory crossbars to understand how those work. Prints are lettered, A, B/C, & D. The only difference between them is a slight notch out of the corners to clear some raised lettering on the factory roof rails to ensure no modification needs to be done to the factory plastic. Did a full writeup on a Dodge Durango forum if you'd like some more details: https://www.dodgedurango.net/threads/aftermarket-crossbars-on-factory-stow-n-place-roof-rails-heres-an-idea.79581
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed