Cup Holder Insert
2011 Ford Expedition
Description
Unknown what other trucks it will fit. Probably Expy 2011-2014 and maybe the F-150's of that year. I got tired of the large cup holders in my truck so I made these to insert into the cup holders to hold bottles. There's also an insert for cans and smaller water bottles. it is slightly beveled because the cup holders get smaller toward the bottom. Works for middle cup holders too but you will probably want to shorten the height to fit them. This is 88 mm. Use ABS or if it gets into the sun and it gets hot inside your vehicle, PLA and PETG will melt. Can insert which will hold smaller water bottles is https://www.thingiverse.com/thing:4461396
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Unknown what other trucks it will fit. Probably Expy 2011-2014 and maybe the F-150's of that year. I got tired of the large cup holders in my truck so I made these to insert into the cup holders to hold bottles. There's also an insert for cans and smaller water bottles. it is slightly beveled because the cup holders get smaller toward the bottom. Works for middle cup holders too but you will probably want to shorten the height to fit them. This is 88 mm. Use ABS or if it gets into the sun and it gets hot inside your vehicle, PLA and PETG will melt. Can insert which will hold smaller water bottles is https://www.thingiverse.com/thing:4461396
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed