Cup Holder Rubber Tab Gaskets
2011 Volvo S40
Description
Cup holder "rubber" tab gaskets for a 2011 Volvo S40. The original rubber tabs for cup holders in older cars often get brittle and break off. Printed with 95A TPU at 100% Infill. NOTES: 1. Print 2 of each part. 2. The parts are 1.5mm high. If this is too tight to get the cup holder lid to snap on, simply scale the height down to 1.0mm.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.
Part Description
Cup holder "rubber" tab gaskets for a 2011 Volvo S40. The original rubber tabs for cup holders in older cars often get brittle and break off. Printed with 95A TPU at 100% Infill. NOTES: 1. Print 2 of each part. 2. The parts are 1.5mm high. If this is too tight to get the cup holder lid to snap on, simply scale the height down to 1.0mm.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Fit Reports
How this part printed and fit, from the community.