Armrest Delete Cover
2013 Fiat 500
Description
This is a "cover" for the armrest mounting pole in the 2013 US model Fiat 500 (and other models that use the same armrest mount) Removing the armrest is a simple matter of pushing the seat material in far enough to remove a retaining clip. But this leaves a hole in the seat with a post protruding about 20mm. This fixes that problem using the same retaining clip, with no permanent damage to your seat or armrest. I have also included the files for the coupler only. Just in case you want to put something other than a dome there. Keep in mind you will still need to provide a hole for the post (12mm dia, 20mm deep) My design is not a load bearing one, so your print settings should not matter structurally. Just print it so it looks good enough for you. I printed it oriented as a "mushroom" so that the "bottom" would be pressed against the seat. That way I could be sloppy removing the supports. and the dome would still look decent even with a quick print.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a "cover" for the armrest mounting pole in the 2013 US model Fiat 500 (and other models that use the same armrest mount) Removing the armrest is a simple matter of pushing the seat material in far enough to remove a retaining clip. But this leaves a hole in the seat with a post protruding about 20mm. This fixes that problem using the same retaining clip, with no permanent damage to your seat or armrest. I have also included the files for the coupler only. Just in case you want to put something other than a dome there. Keep in mind you will still need to provide a hole for the post (12mm dia, 20mm deep) My design is not a load bearing one, so your print settings should not matter structurally. Just print it so it looks good enough for you. I printed it oriented as a "mushroom" so that the "bottom" would be pressed against the seat. That way I could be sloppy removing the supports. and the dome would still look decent even with a quick print.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed