Watertight Headlight Cap
2014 Hyundai Sonata
Description
I upgraded my headlights on my 2014 Hyundai Sonata and needed to print a modified version to fit my LED heatsink. Since I did not see a standard replacement cap I figured I would upload this one. If you use Cura for slicing I have included my Cura Profile used to print this piece. Be aware you will need to reuse the rubber gasket to get the water tight seal. UPDATE: 9/11/2020 Do not use PLA unless you plan on annealing it. LEDs melted the side supports on my print. I suggest PETG or ABS for replacement.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I upgraded my headlights on my 2014 Hyundai Sonata and needed to print a modified version to fit my LED heatsink. Since I did not see a standard replacement cap I figured I would upload this one. If you use Cura for slicing I have included my Cura Profile used to print this piece. Be aware you will need to reuse the rubber gasket to get the water tight seal. UPDATE: 9/11/2020 Do not use PLA unless you plan on annealing it. LEDs melted the side supports on my print. I suggest PETG or ABS for replacement.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed