Trunk Handle
2015-2021 Subaru Wrx/sti
Description
This is a remix of srwall's WRX Trunk Handle. I made the posts shorter to make it sit more flush as well as adjusted the holes to better fit standard M6-1.0x16mm bolts (easier to find than hex key hardware), as well as leaving room to actually fit a 10mm nut driver or ratchet in to tighten them down. Also made the holes for the threaded parts narrower for better strength though I still recommend washers. Thanks again for the great design srwall!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a remix of srwall's WRX Trunk Handle. I made the posts shorter to make it sit more flush as well as adjusted the holes to better fit standard M6-1.0x16mm bolts (easier to find than hex key hardware), as well as leaving room to actually fit a 10mm nut driver or ratchet in to tighten them down. Also made the holes for the threaded parts narrower for better strength though I still recommend washers. Thanks again for the great design srwall!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed