Console Cup Holder
2016-2018 Tesla Model S
Description
This is hopefully an improvement to the existing cup holder on the Tesla model s. I designed this for a Tesla Model S 2016, but it should fit 2016-2018. I've provided measurements in the drawing below, so please measure to confirm before printing this, since this will be a long print, at at least 17 hours on most 3D printers. Important note. The console sliding cover will not close when this is installed. This is not intended to be permanent. Please see the picture that shows how this fits in the car. Print without supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is hopefully an improvement to the existing cup holder on the Tesla model s. I designed this for a Tesla Model S 2016, but it should fit 2016-2018. I've provided measurements in the drawing below, so please measure to confirm before printing this, since this will be a long print, at at least 17 hours on most 3D printers. Important note. The console sliding cover will not close when this is installed. This is not intended to be permanent. Please see the picture that shows how this fits in the car. Print without supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed