Splash Shield Mounting Clip
2017 Ford Edge
Description
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/hO03kdXYThL I just bought a 2017 Ford Edge and at 65MPH on a windy day I noticed a loud vibrating sound from the bottom of the car. There is a splash shield under the car that runs on both sides from front axle to back axle. When I would move that with my hand I noticed it sounded very loud and loose in the middle. (I tested a 2015 for this issue and it was tight) So I figured mine just had worn out mounting clips. I printed these clips to fill the gap between the Ford mounting clip and the shroud. I hope this helps and will report back the results if the sound goes away. THE SOUND DID GO AWAY!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/hO03kdXYThL I just bought a 2017 Ford Edge and at 65MPH on a windy day I noticed a loud vibrating sound from the bottom of the car. There is a splash shield under the car that runs on both sides from front axle to back axle. When I would move that with my hand I noticed it sounded very loud and loose in the middle. (I tested a 2015 for this issue and it was tight) So I figured mine just had worn out mounting clips. I printed these clips to fill the gap between the Ford mounting clip and the shroud. I hope this helps and will report back the results if the sound goes away. THE SOUND DID GO AWAY!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed