Center Console Organizer
2018-2024 Toyota Camry Gen8
Description
Just a simple partial tray for the center armrest. This tray is intended to sit towards the rear of the arm rest bin. It shouldn't move. The tray is not intended to be lifted to access the stuff living underneath since the front portion is mostly open for access below and to provide room for any cables plugged into the front of the bin in case your car has those plugs like my XLE. Print with ABS filament or something more heat resistant. Infill and number of walls should not play a major role since we're not storing super heavy items where strength would be very important, so use whatever your default settings your preferred slicer suggests. Supports are necessary. Use 5 walls just in case V2x model is slightly larger and has a thicker ledge to reduce warping during printing as well as increase strength to resist breaking in the car. note: v27 fits very snug and quarters make the cover a bit hard to close. V28 adjusts the fit as well as reposition the quarters in an attempt to have a slightly lower profile. I've yet to print it for testing since I'm out of filament (and ADHD energy). I'm printing with the opening facing down. I'm using an outer brim because I'm hoping to reduce the warping.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Just a simple partial tray for the center armrest. This tray is intended to sit towards the rear of the arm rest bin. It shouldn't move. The tray is not intended to be lifted to access the stuff living underneath since the front portion is mostly open for access below and to provide room for any cables plugged into the front of the bin in case your car has those plugs like my XLE. Print with ABS filament or something more heat resistant. Infill and number of walls should not play a major role since we're not storing super heavy items where strength would be very important, so use whatever your default settings your preferred slicer suggests. Supports are necessary. Use 5 walls just in case V2x model is slightly larger and has a thicker ledge to reduce warping during printing as well as increase strength to resist breaking in the car. note: v27 fits very snug and quarters make the cover a bit hard to close. V28 adjusts the fit as well as reposition the quarters in an attempt to have a slightly lower profile. I've yet to print it for testing since I'm out of filament (and ADHD energy). I'm printing with the opening facing down. I'm using an outer brim because I'm hoping to reduce the warping.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed