Homelink Bracket
2023 Tesla Model Y
Description
Bracket to retrofit a HomeLink garage door opener into a 2023 Tesla Model Y. Remixed rhovey's bracket with the following changes: 1) Changed mounting position to more closely align with the actual Tesla bracket (from pmlody’s design https://www.printables.com/model/382187-tesla-3-homelink-bracket) 2) Reduced much of the bulk from original design to reduce signal interference 3) Tuned up a few of the joints to add stability 4) Added holes to accommodate a zip tie to help secure the module into the bracket (don't over-tighten the zip tie!) Reference this video for the step-by-step process (module part number and bolt size included in the video description). https://youtu.be/6_5_g_Wc75A Installation and configuration took me only about 20 min total, and did NOT require a Tesla technician. YMMV. Print settings: Supports enabled 55% infill PETG filament to increase durability and heat tolerance .20 resolution
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Bracket to retrofit a HomeLink garage door opener into a 2023 Tesla Model Y. Remixed rhovey's bracket with the following changes: 1) Changed mounting position to more closely align with the actual Tesla bracket (from pmlody’s design https://www.printables.com/model/382187-tesla-3-homelink-bracket) 2) Reduced much of the bulk from original design to reduce signal interference 3) Tuned up a few of the joints to add stability 4) Added holes to accommodate a zip tie to help secure the module into the bracket (don't over-tighten the zip tie!) Reference this video for the step-by-step process (module part number and bolt size included in the video description). https://youtu.be/6_5_g_Wc75A Installation and configuration took me only about 20 min total, and did NOT require a Tesla technician. YMMV. Print settings: Supports enabled 55% infill PETG filament to increase durability and heat tolerance .20 resolution
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed