Door Latch Bushing
1965-1967 Ford Mustang
Description
This is a replacement door latch bushing for a 1965-67? Ford mustang, Left and Right should be the same. the push/pull rod nests into the interior and clips in into the little latch groove. I found luck printing in PLA on edge to combat layer line weakness in the thinnest part of the shaft , Printed solid, with supports and it needed a little cleanup after. I printed it on a Bambu labs X1C, this is the 4th iteration, but the only one that fit properly.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a replacement door latch bushing for a 1965-67? Ford mustang, Left and Right should be the same. the push/pull rod nests into the interior and clips in into the little latch groove. I found luck printing in PLA on edge to combat layer line weakness in the thinnest part of the shaft , Printed solid, with supports and it needed a little cleanup after. I printed it on a Bambu labs X1C, this is the 4th iteration, but the only one that fit properly.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed