Bonnet Moulding Clip
1966-1970 Toyota Corolla KE10
May 4, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
I recently purchased a KE10 Corolla project car. The bonnet moulding was inside the car and missing 4 out of 5 clips to hold it on, and I simply could not find an aftermarket replacement anywhere, so I knocked up these. I hope they help other old Toyota enthusiasts. Print with the rectangular base face down on your bed.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
I recently purchased a KE10 Corolla project car. The bonnet moulding was inside the car and missing 4 out of 5 clips to hold it on, and I simply could not find an aftermarket replacement anywhere, so I knocked up these. I hope they help other old Toyota enthusiasts. Print with the rectangular base face down on your bed.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed