Battery Hold Down Bracket
1969-1973 Datsun 240z S30
Description
This is a replacement battery hold down bracket for a 240z / 260z / Fairlady Z. It uses the stock firewall bolt hole and the standard tie down rod (that connects to the battery tray). It can be used with new smaller and lower batteries. I printed in Nylon to ensure it could deal with the warm temperatures in the engine bay and was not brittle. PETG or other higher temperature filaments might also be suitable. Print orientation - print as it will be placed in the car. Supports are required for the long area that contacts the battery.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a replacement battery hold down bracket for a 240z / 260z / Fairlady Z. It uses the stock firewall bolt hole and the standard tie down rod (that connects to the battery tray). It can be used with new smaller and lower batteries. I printed in Nylon to ensure it could deal with the warm temperatures in the engine bay and was not brittle. PETG or other higher temperature filaments might also be suitable. Print orientation - print as it will be placed in the car. Supports are required for the long area that contacts the battery.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed