Mini Atx Fuse Adapter
1969 Ford Mustang
Description
Designed for my 69 Mustang but i have found this will fit multiple models such as a 69 Cougar or 71 Torino Fuse holder/adapter based off https://www.thingiverse.com/thing:1893269 <B>Mini ATX Adapter for our 69 Mustang buss fuse panels.</B> <font color="red"><I>This requires cutting the brass bar into sections, beveling out the edge, and soldering connectors to it</I></font> 1) - ACC Type - For adding the Accessory wire where a fuse isn't present 2) - FULL - Where the fuse is present and has the screw connector 3) - ACC-Bolt - Allows you to add a small bolt to connect to the ACC Accessory instead of using a wire lead <B>Configuration Types: </B> 1) - Bolt-On Requires removal of the unit and to put the bolt through. Does eliminate the ability to use the push on washer that holds it to the Wiring harness. Only matters for removal really 2) - Push-ON....The center hole will push around the bolt and is held in by the bus fuse holders. Contacts: http://www.digikey.com/product-detail/en/keystone-electronics/3557/36-3557-ND/2092485 Brass Bar: https://www.amazon.com/gp/product/B0748DQ1MP
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Designed for my 69 Mustang but i have found this will fit multiple models such as a 69 Cougar or 71 Torino Fuse holder/adapter based off https://www.thingiverse.com/thing:1893269 <B>Mini ATX Adapter for our 69 Mustang buss fuse panels.</B> <font color="red"><I>This requires cutting the brass bar into sections, beveling out the edge, and soldering connectors to it</I></font> 1) - ACC Type - For adding the Accessory wire where a fuse isn't present 2) - FULL - Where the fuse is present and has the screw connector 3) - ACC-Bolt - Allows you to add a small bolt to connect to the ACC Accessory instead of using a wire lead <B>Configuration Types: </B> 1) - Bolt-On Requires removal of the unit and to put the bolt through. Does eliminate the ability to use the push on washer that holds it to the Wiring harness. Only matters for removal really 2) - Push-ON....The center hole will push around the bolt and is held in by the bus fuse holders. Contacts: http://www.digikey.com/product-detail/en/keystone-electronics/3557/36-3557-ND/2092485 Brass Bar: https://www.amazon.com/gp/product/B0748DQ1MP
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed