Rim Blow Steering Wheel Insulator
1969 Ford Mustang
Description
This is a replacement 1969 Ford Mustang Rim Blow Steering Wheel Insulator. It is a near exact duplicate of the original, which tends to shrink and crack over time. There are 2 files available. An original reproduction and an improved (Thicker & Taller) model. Either will work, but the improved model just seems to fit better and should be less prone to breaking. Neither model includes the notches in the bottom of the ring, because I didn't actually see the use of those, except maybe it made it easier during assembly. In the few rings that I've seen, they always seem to crack right at the notch, where the height is narrower. Not sure the settings matter much, but here's what I used: 0.1mm Profile 0.8 Wall Thickness 2 Wall Line Count 100 Infill No supports needed No Plate Adhesion needed
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a replacement 1969 Ford Mustang Rim Blow Steering Wheel Insulator. It is a near exact duplicate of the original, which tends to shrink and crack over time. There are 2 files available. An original reproduction and an improved (Thicker & Taller) model. Either will work, but the improved model just seems to fit better and should be less prone to breaking. Neither model includes the notches in the bottom of the ring, because I didn't actually see the use of those, except maybe it made it easier during assembly. In the few rings that I've seen, they always seem to crack right at the notch, where the height is narrower. Not sure the settings matter much, but here's what I used: 0.1mm Profile 0.8 Wall Thickness 2 Wall Line Count 100 Infill No supports needed No Plate Adhesion needed
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed