Clock Gear
1974-1978 Cadillac Eldorado
Description
Replacement model for the brown gear found in these year clocks that always are missing Resin print is basically required for this small scale and i recommend using a small amount of silicone to attack the gear, or else it can slip REVISED So the original designed gear was slightly too big and had a problem where over the course of a few weeks the clock will stop working because the gear would build up friction against the edges and stall. This happened because in order for the gear to sit in properly it needed to be put in pretty loose. I thought this was normal and a result of how the clock was designed but NOPE. The issue is solved but this slightly smaller version of the gear which allows it to be tightened all of the way. Allowing the gear to sit solidly inside the clock with now irregular movements SCALE scale the gear to 50% of its size in whichever slicer you put it in. The gear should measure about 6 mm total width when scaled to 50%
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Replacement model for the brown gear found in these year clocks that always are missing Resin print is basically required for this small scale and i recommend using a small amount of silicone to attack the gear, or else it can slip REVISED So the original designed gear was slightly too big and had a problem where over the course of a few weeks the clock will stop working because the gear would build up friction against the edges and stall. This happened because in order for the gear to sit in properly it needed to be put in pretty loose. I thought this was normal and a result of how the clock was designed but NOPE. The issue is solved but this slightly smaller version of the gear which allows it to be tightened all of the way. Allowing the gear to sit solidly inside the clock with now irregular movements SCALE scale the gear to 50% of its size in whichever slicer you put it in. The gear should measure about 6 mm total width when scaled to 50%
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed