Door Seal Clip
1977-1985 Mercedes-benz W123 W123 (Coupe)
Description
This is a model of Mercedes seal clip for W123 Coupe model, part number A0009871015 (for reference only). Measurements taken from an original part (see photo). I've used PLA for a prototype, then ASA for the final version, but I think nylon would be best. I've also made few with PETG and they were also fine. For better strength it should be printed in a horizontal position (as on attached Cura screenshot).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a model of Mercedes seal clip for W123 Coupe model, part number A0009871015 (for reference only). Measurements taken from an original part (see photo). I've used PLA for a prototype, then ASA for the final version, but I think nylon would be best. I've also made few with PETG and they were also fine. For better strength it should be printed in a horizontal position (as on attached Cura screenshot).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed