Blank Dash Bezel
1979-1986 Ford Mustang Fox Body
Description
Updated, Split top section from bottom for easier printing and slicing so you can stagger seams for a stronger end result. Also corners fit better, top screw holes my need ovaled for installation. Made a remix of the 79-86 Mustang dash bezel @restoprintsllc made. Filled in all of the factory openings so I could customize it how I like and rounded off the corners for a better fit. I had to slice it into thirds and used a few alignment tabs along with plastic epoxy to attach them together. I printed it out in Flashforge PETG-CF Midnight Blue filament. On a Elegoo Centauri Carbon with 0.2 layer height with a 0.4 mm Brass-Hardened Steel tip.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Updated, Split top section from bottom for easier printing and slicing so you can stagger seams for a stronger end result. Also corners fit better, top screw holes my need ovaled for installation. Made a remix of the 79-86 Mustang dash bezel @restoprintsllc made. Filled in all of the factory openings so I could customize it how I like and rounded off the corners for a better fit. I had to slice it into thirds and used a few alignment tabs along with plastic epoxy to attach them together. I printed it out in Flashforge PETG-CF Midnight Blue filament. On a Elegoo Centauri Carbon with 0.2 layer height with a 0.4 mm Brass-Hardened Steel tip.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed