Part Description

i added the second design with the slot between the cups but i have not tested it just FYI cupholder for foxbody console i designed, will require trimming the factory console ashtray door and surrounding area a little. i just used a dremel. epoxy this in place and use whatever means you find fit to fill in gaps (fiberglass, bondo, filler, epoxy) i would recommend using abs because im not sure PLA would hold up to the heat inside the car in the summer.

Print Instructions

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed