Door Speaker Grille
1984-1989 Chevrolet Corvette C4
Description
A while back, I put speakers into my 85 but couldn't get the grilles to fit with them, so I made these ones in Fusion 360. I tried to get them to look pretty close to the original ones, but with extra space since the grille was hitting the tweeters, it ended up being around 0.8 inches of extra space. It uses the same screws as the old ones, so it should be a direct replacement. When printing them, I had to lower the retraction settings in Cura since my nozzle was clogging, so if you have that issue, that's how I got it to work.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
A while back, I put speakers into my 85 but couldn't get the grilles to fit with them, so I made these ones in Fusion 360. I tried to get them to look pretty close to the original ones, but with extra space since the grille was hitting the tweeters, it ended up being around 0.8 inches of extra space. It uses the same screws as the old ones, so it should be a direct replacement. When printing them, I had to lower the retraction settings in Cura since my nozzle was clogging, so if you have that issue, that's how I got it to work.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed