Cup Holder
1984-1989 Nissan 300zx Z31
Description
Another cup holder option to rival the others out there. Personally I like it tucked away in the center console. Been using this design in all my Z's for some time now. Figured I should share. Leaves enough space to still put junk in the console, big enough to hold decent sized cups. It is a snug fit. Not permanently held in. Easy to pop out. My PETG prints have held up for 2-3 years in the summer. PLA prints will not survive any heat in a car. The space in front or behind still can fit a few cassettes, or see below for a divider A divider has been made by pthomas2000 to fit perfectly behind to lock this in place [https://www.thingiverse.com/thing:5761587](https://www.thingiverse.com/thing:5761587)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Another cup holder option to rival the others out there. Personally I like it tucked away in the center console. Been using this design in all my Z's for some time now. Figured I should share. Leaves enough space to still put junk in the console, big enough to hold decent sized cups. It is a snug fit. Not permanently held in. Easy to pop out. My PETG prints have held up for 2-3 years in the summer. PLA prints will not survive any heat in a car. The space in front or behind still can fit a few cassettes, or see below for a divider A divider has been made by pthomas2000 to fit perfectly behind to lock this in place [https://www.thingiverse.com/thing:5761587](https://www.thingiverse.com/thing:5761587)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed