Rear Wiper Switch Cap
1989-1991 Mazda Rx-7 FC3S (S5)
Description
This is the cap that goes on the rear wiper switch for a S5 (possibly S4 as well) coupe. It may also work for the convertible cover switch as well. Note that if you intent on using the original metal stud, there is a particular orientation that it needs to be installed at or it will not line up like the factory cap. The model with the stud shows the correct orientation relative to the 2 "fat" serrations on the outside diameter of the cap.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is the cap that goes on the rear wiper switch for a S5 (possibly S4 as well) coupe. It may also work for the convertible cover switch as well. Note that if you intent on using the original metal stud, there is a particular orientation that it needs to be installed at or it will not line up like the factory cap. The model with the stud shows the correct orientation relative to the 2 "fat" serrations on the outside diameter of the cap.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed