Rear Window Bottom Trim Clips
1990 Ford Ltd Crown Victoria
Description
I needed replacement trim clips for a project car I was working on. The vehicle requires 8 total clips, and all but 3 were missing. My final print was in PETG, so they came out a little rough visually, but they clipped into place and have been holding well. Photos show one of the remaining OEM trim clips next to the one printed in PETG. To print, I used the automatic supports in Prusa Slicer. I oriented the print with the slot facing down, and the clip on its edge (same as the Thingiverse model preview, but with the slot pointed down instead of up).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I needed replacement trim clips for a project car I was working on. The vehicle requires 8 total clips, and all but 3 were missing. My final print was in PETG, so they came out a little rough visually, but they clipped into place and have been holding well. Photos show one of the remaining OEM trim clips next to the one printed in PETG. To print, I used the automatic supports in Prusa Slicer. I oriented the print with the slot facing down, and the clip on its edge (same as the Thingiverse model preview, but with the slot pointed down instead of up).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed