Wideband Gauge Vent Mount
1990-2004 Mazda Mx-5 NA/NB (NBFL)
Description
I made this design so I could fit my AEM Wideband O2 controller into one of my "eye ball" air vent inlets in my 2002 MX-5 NBFL. It is compatible with all MX-5s from 1990 to 2004, as far as I know these models had the same vent holes. I printed it on my Creality LD-002H SLA printer, with 85% support from baseplate. I don't think, that this would be too good with an FDM printer, but I didn't try it. If you find this model useful and is a help for you, consider leaving a tip of a few bucks, I would be very grateful. For hungarians: // If you see someone selling this for printing in Hungarian Mazda groups, I ask for a share, after all I was the one who modeled it :D //
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I made this design so I could fit my AEM Wideband O2 controller into one of my "eye ball" air vent inlets in my 2002 MX-5 NBFL. It is compatible with all MX-5s from 1990 to 2004, as far as I know these models had the same vent holes. I printed it on my Creality LD-002H SLA printer, with 85% support from baseplate. I don't think, that this would be too good with an FDM printer, but I didn't try it. If you find this model useful and is a help for you, consider leaving a tip of a few bucks, I would be very grateful. For hungarians: // If you see someone selling this for printing in Hungarian Mazda groups, I ask for a share, after all I was the one who modeled it :D //
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed