Air Vent
1990-1997 Mazda Miata NA
Description
Drop in air duct replacment for the NA miata. There is also a closed up version of the upper ring and one with holes for a magnetic car holder that I own (baseus). Print in ABS because of the temperature and I found that the lower ring is much stronger when printed on a side with support in the middle. If the ball inside is too loose use duct tape inside the lower ring or some foam.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Drop in air duct replacment for the NA miata. There is also a closed up version of the upper ring and one with holes for a magnetic car holder that I own (baseus). Print in ABS because of the temperature and I found that the lower ring is much stronger when printed on a side with support in the middle. If the ball inside is too loose use duct tape inside the lower ring or some foam.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed