Armrest
1990-1997 Mazda Miata NA
Description
This is a replacement armrest for the center console portion of an NA Mazda Miata. Mine cracked so I designed this to take its place. I never got it fully printed before I unfortunately had to let the Miata go. The fitment should be correct as both halves were printed and set in the car but never fully mounted together with the pegs. It is split into 2 pieces in order to fit my print bed on a Wanhao Duplicator I3. I was going to fit it together with the pegs and glue to two halves once fitment was verified. I printed each half standing straight up with the split facing down onto the bed. I printed with supports. I recommend ABS as I'm not sure PLA or PETG would stand up to sitting in the heat of the sun in the car. Good luck! I hope it fits. If it needs some tweaking just let me know and I can provide my model files. This was designed in Fusion 360.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a replacement armrest for the center console portion of an NA Mazda Miata. Mine cracked so I designed this to take its place. I never got it fully printed before I unfortunately had to let the Miata go. The fitment should be correct as both halves were printed and set in the car but never fully mounted together with the pegs. It is split into 2 pieces in order to fit my print bed on a Wanhao Duplicator I3. I was going to fit it together with the pegs and glue to two halves once fitment was verified. I printed each half standing straight up with the split facing down onto the bed. I printed with supports. I recommend ABS as I'm not sure PLA or PETG would stand up to sitting in the heat of the sun in the car. Good luck! I hope it fits. If it needs some tweaking just let me know and I can provide my model files. This was designed in Fusion 360.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed