Visor Clip
1990 Subaru Brumby
Description
I made this visor clip for my 1990 brumby as the stock ones where falling apart and no longer served there purpose, i couldnt find any online to buy so i just made my own copy. This model was version 4, and most likely wont recive any updates in the future. Super easy to install just remove old ones and screw these ones in. Might have to sand the slip part to fit a little more stock but with out sanding it fits super snug. Print takes about 1 hour with my settings ofc you can put infill lower which will decrease print time. Other than that hope this works for you!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I made this visor clip for my 1990 brumby as the stock ones where falling apart and no longer served there purpose, i couldnt find any online to buy so i just made my own copy. This model was version 4, and most likely wont recive any updates in the future. Super easy to install just remove old ones and screw these ones in. Might have to sand the slip part to fit a little more stock but with out sanding it fits super snug. Print takes about 1 hour with my settings ofc you can put infill lower which will decrease print time. Other than that hope this works for you!
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed