Blend Door Actuator Gear Set
1990-1996 Nissan 300zx Z32
Description
This is a set of gears intended for use to replace the broken gears in a 300ZX blend door actuator. This includes all the gears in the geartrain except the worm on the motor, which I could not extract to model. Shown in the pictures is a small puller I had to make to remove the actuator arm intact. Given the forces this is subject to, I would not recommend printing these in anything short of ABS or Nylon, at 100% infill. I printed in Taulman 910. They are based on the Parametric Involute Bevel and Spur Gear library by GregFrost. As such, it is licensed under the Creative Commons - GNU LGPL 2.1 license. The source code is included in the thing, in the .scad file.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a set of gears intended for use to replace the broken gears in a 300ZX blend door actuator. This includes all the gears in the geartrain except the worm on the motor, which I could not extract to model. Shown in the pictures is a small puller I had to make to remove the actuator arm intact. Given the forces this is subject to, I would not recommend printing these in anything short of ABS or Nylon, at 100% infill. I printed in Taulman 910. They are based on the Parametric Involute Bevel and Spur Gear library by GregFrost. As such, it is licensed under the Creative Commons - GNU LGPL 2.1 license. The source code is included in the thing, in the .scad file.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed