Cup Holder
1991 Mazda Miata NA
May 5, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
This fits into the panel holes on a gutted 1991 Mazda Miata. I assume all the panels have these holes. Only works if you don't have carpet. The print required a tiny amount of sanding for me so I bumped the pin width down 1mm for each but I haven't tested it - hopefully you won't need to shave them down at all.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
This fits into the panel holes on a gutted 1991 Mazda Miata. I assume all the panels have these holes. Only works if you don't have carpet. The print required a tiny amount of sanding for me so I bumped the pin width down 1mm for each but I haven't tested it - hopefully you won't need to shave them down at all.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed