Boot Release Cable Clip
1991 Nissan S13
Description
replacement part for the S13 silvia and 180sx boot release latch guide. its the bit with the plastic thread that always seems to break on these. this has been printed and tested to work on an s13. my print settings were very rough so some fettling was required (with a better printer and settings the part should fit spot on). i used support material from the same extruder so it was fairly well bonded. printed with nylon filament.
Print Instructions
Printer Brand: Prusa Printer: i3 MK2S Rafts: No Supports: Yes Resolution: 0.2mm layer height/0.4mm line width Infill: 0.4mm Filament: geeetech Nylon black
Part Description
replacement part for the S13 silvia and 180sx boot release latch guide. its the bit with the plastic thread that always seems to break on these. this has been printed and tested to work on an s13. my print settings were very rough so some fettling was required (with a better printer and settings the part should fit spot on). i used support material from the same extruder so it was fairly well bonded. printed with nylon filament.
Print Instructions
Printer Brand: Prusa Printer: i3 MK2S Rafts: No Supports: Yes Resolution: 0.2mm layer height/0.4mm line width Infill: 0.4mm Filament: geeetech Nylon black