Sunvisor Clip
1991-1998 Volkswagen Golf MK3
Description
Much tanks to mco_martins here on Thingiverse for the original design! I was searching for something a little more cleaned up, and decided to just throw the original mesh in fusion and remix it to look a little more like the factory clips. I also added a small, blended countersink for the single screw. Remodeled in Fusion 360, and an F3Z file is included. As with the original file, this is a right seat side, if you need a drivers side just mirror it in your slicer! **Thankfully, a member of the community notified me shortly after uploading that an error had occurred with my original STL file. This error has been fixed.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Much tanks to mco_martins here on Thingiverse for the original design! I was searching for something a little more cleaned up, and decided to just throw the original mesh in fusion and remix it to look a little more like the factory clips. I also added a small, blended countersink for the single screw. Remodeled in Fusion 360, and an F3Z file is included. As with the original file, this is a right seat side, if you need a drivers side just mirror it in your slicer! **Thankfully, a member of the community notified me shortly after uploading that an error had occurred with my original STL file. This error has been fixed.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed